SmartSwap технологія
| Виробник:
TA Instruments |
 |
SmartSwap - is a technology that automatically senses the temperature control system present and configures the rheometer operating software accordingly, loading all relevant calibration data.
The magnetic coating on the head of each geometry provides the read/write technology that will uniquely identify it to the instrument.
Smart Swap™ geometries are an extension of the Smart Swap technology. These geometries can be automatically identified when installed on the DHR or ARES-G2 Rheometer. The magnetic strip on the head of each geometry provides the information that will uniquely identify it to the instrument. These geometries are resistant to changes in temperature and the use of solvents and do not interfere with your experiment in any way.
The Smart Swap geometries have a larger diameter than previous geometries, which is required to record sufficient data (36 bits) around the circumference. In addition, the geometries have a larger bore to allow a better location surface and easier cleaning.
Each geometry has a unique six-digit serial number for identification purposes. When the geometry is set up for the first time this number is encoded into the magnetic strip and a link is established to a geometry file in the instrument control software. The geometry then becomes "Smart."
When a Smart Swap Geometry is attached to the rheometer, a sensor registers the attachment and slowly spins the shaft to read the serial number from the magnetic strip. The geometry file associated with this serial number is then loaded by the software.
- NOTE: Upper Heated Plate geometries cannot be totally smart as the geometry screws into the heat spreader. You will be given a list of all UHP geometries in the database when a heat spreader is identified.
The Environmental Test Chamber (ETC) geometries, with the exception of disposable plates, are available with the Smart Swap technology.
Previous AR Peltier geometries (with a narrow bore) can be used with a smart adapter. You will be given a list of all standard geometries in the database when the adapter is identified.
Відео